Frequently Asked Questions
The certification test consists of two separate tests. The before-blasting sieve test and the after-blasting hydrometer test.
The producer or vendor of an abrasive which fails the before-blasting sieve test has three options on how to proceed:
- They may choose to abandon further testing. In this case, they will only be charged for the sieve test and the return/disposal of the tested abrasive sample.
- They may choose to resubmit the abrasive sample for retesting. In this case, they will be charged for the original sieve test, all testing done on the resubmitted abrasive sample and the return/disposal of the both tested abrasive samples.
- They may choose to demonstrate that the abrasive meets twenty percent opacity when blasted in accordance with the Visible Emissions Evaluation (VEE) test method. They are responsible for arranging for the test to be conducted at a site in California. CARB will provide a representative to do the opacity reading. In this case they will be charged for the sieving and blasting test of the abrasive sample, and the return/disposal of the tested abrasive sample, as well as for the costs to do the opacity reading. Any additional costs to perform the VEE test are separate for CARB invoicing. It should also be noted that normal certification testing uses the entire abrasive sample provided to CARB. Additional abrasive must be shipped to the VEE test site.
If the abrasive fails the after-blasting hydrometer test, it cannot be certified.
The cost varies since the total cost for testing in a given period is divided by the number of abrasives submitted for certification during that period. Therefore, the cost may be lower if more abrasives are submitted or higher if less are submitted. In general, the cost is expected to be between $1,800 and $2,400 per abrasive sample plus disposal/return costs.
No. Abrasives do not need to certified if:
- They are used inside a permanent building, or
- They are made from steel or iron shot/grit, exclusively, or
- They are used with compressed air as the propelling force, using water to minimize the plume, or
- They are used with high pressure liquid as the propelling force, or
- The spent abrasive, surface material, and dust are immediately collected by a vacuum device.
For more detail, the California Code of Regulations, title 17, sections 92000 - 92530 is available online.
Have you ever wondered what a baghouse is or what NMOG stands for?